Information for Patients
Dislocations are joint injuries that force the ends of your bones out of position. The cause is often a fall or a blow, sometimes from playing a contact sport. You can dislocate your ankles, knees, shoulders, hips, elbows and jaw. You can also dislocate your finger and toe joints. Dislocated joints often are swollen, very painful and visibly out of place. You may not be able to move it.
A dislocated joint is an emergency. If you have one, seek medical attention. Treatment depends on which joint you dislocate and the severity of the injury. It might include manipulations to reposition your bones, medicine, a splint or sling, and rehabilitation. When properly repositioned, a joint will usually function and move normally again in a few weeks. Once you dislocate a shoulder or kneecap, you are more likely to dislocate it again. Wearing protective gear during sports may help prevent dislocations.
Toe Injuries and Disorders
Fourteen of the 26 bones in your feet are in your toes. The toes, particularly your big toe, help you move and keep your balance. Playing sports, running, stubbing your toe, and dropping something on your foot can damage your toes. Wearing shoes that are too loose or too tight can also cause toe problems. Certain diseases, such as severe arthritis, can cause toe problems and pain. Gout often causes pain in the big toe.
Common toe problems include
- Corns and bunions
- Ingrown toenails
- Sprains and dislocations
Treatments for toe injuries and disorders vary. They might include shoe inserts or special shoes, padding, taping, medicines, rest, and in severe cases, surgery.
General Equivalence Map Definitions
The ICD-10 and ICD-9 GEMs are used to facilitate linking between the diagnosis codes in ICD-9-CM and the new ICD-10-CM code set. The GEMs are the raw material from which providers, health information vendors and payers can derive specific applied mappings to meet their needs.
- Approximate Flag - The approximate flag is on, indicating that the relationship between the code in the source system and the code in the target system is an approximate equivalent.
- No Map Flag - The no map flag indicates that a code in the source system is not linked to any code in the target system.
- Combination Flag - The combination flag indicates that more than one code in the target system is required to satisfy the full equivalent meaning of a code in the source system.